2. Installation
2.1 Initial Check
Packaging
The Serinus 44 is transported in packaging which is specifically designed to minimise the effects of
shock and vibration during transportation. Ecotech recommends that the packaging be kept if there
is a likelihood that the instrument is going to be relocated.
Note: The red plastic caps that seal the pneumatic connections during transport must be removed
prior to operation.
Opening the Instrument
Check the interior of the instrument with the following steps:
1. Undo the screws located in the rear panel.
2. Open the chassis lid by releasing the latch (pressing the button) located on the front panel in the
top left-hand corner, slide the lid backwards.
3. To completely remove; slide the lid backwards until the rollers line up with the gaps in the track
and pull the lid upwards to remove from the instrument (refer to Figure 5).
4. Check that all pneumatic and electrical connectors are connected. If not, reconnect.
5. Check for any visible and obvious damage. If damage exists contact your supplier and follow the
instructions in (Claims for Damaged Shipments) and (Shipping Discrepancies) at the front of this
manual.
Figure 5 – Opening the Instrument
To Next Page
Loading...
