Ecotech Serinus 44 - 4.4 Digital;Analog Communication; 4.4.1 Analog Outputs

Serinus 44 User Manual 3.0
Page 70
Below is an example of Airodis setup for a WAN network. Ensure the IP address is set the same as on
the remote modem/router.
Figure 18 – WAN Network Set-Up (Airodis)
4.4 Digital/Analog Communication
The 25 Pin analog/digital port on the rear of the instrument sends and receives analog/digital signals
to other devices. These signals are commonly used to activate gas calibrators or for warning alarms.
4.4.1 Analog Outputs
The instrument is equipped with one to three analog outputs that can be set to provide either
voltage (0-5V, 0.25-5V, 0.5-5V, 0-10V) or current (0-20, 2-20, 4-20mA). The analog outputs are tied to
specific instrument measurements, depending on the instrument type.
For 0-10V analog output operation, set the output type to current and move the jumpers (JP3) on the
rear panel PCA to 0-10V (refer to Figure 14).
Table 4 – Analog Outputs
Analyser
Output 1
Output 2
Output 3
S10
O
3
N/A
N/A
S30
CO
CO
2
[optional]
N/A
S40
NO
NO
X
NO
2
S44
NO
NH
3
NO
2
S50
SO
2
N/A
N/A