Serinus 44 User Manual 3.0
Figure 24 – Installing Driver Confirmation Prompt
If everything went smoothly, Windows will inform you that the driver was successfully installed.
Figure 25 – Successful Driver Installation
4.6.1.2 Connecting Over Serial (RS-232)
The following steps outline how to setup the instrument for connection to a PC or datalogger (refer
to Section 3.4.22).
Procedure
1. Open - Main Menu Communication Menu Serial Communication Menu.
2. Determine which RS232 Port you are physically making the connection with. Remember,
multidrop is only supported on RS232 #2.
3. Select – Baudrate 38400 - Accept (Set an appropriate baud rate, default is 38400).
To Next Page
Loading...
