Ecotech Serinus 44 - 6.2 Maintenance and Calibration Schedule

Serinus 44 User Manual 3.0
Page 114
Figure 52 – Leak Test Jig – (H050069)
Figure 53 – Air Monitoring Test Equipment Kit (AMTEK) - Customisable
6.2 Maintenance and Calibration Schedule
The maintenance intervals are determined by compliance standards that differ in various regions.
The following is recommended by Ecotech as a guide. Compliance with local regulatory or
international standards is the responsibility of the user.
Table 6 – Maintenance Schedule
Interval *
Task Performed
Section
Nightly
or
Every 5 days
Perform precision check (Automated)
Perform precision check (Manual)
(This task is performed to ensure a high data capture
rate)
5.5