EDAN SE-1201 - Page 98

SE-1201 Electrocardiograph User Manual System Setup
- 91 -
Item Description
Record Device
Options Corresponding USB Printers
HP Deskjet 2010
HP Deskjet 1050
HP Deskjet 2000
HP
2010/1050/2000
HP Deskjet 2050
HP Laserjet P2015
HP2035
HP Laserjet P2035
NOTE:
1. During the USB printing course，pressing the PRINT/STOP key
again can not stop printing ECG reports.
2. For details of the ECG report printed by the USB printer, please
refer to Section 6.5.5, “ECG Reports Printed by the USB
Printer”.
3. USB printing is ineffective in the auto periodic sampling mode,
auto 11~24s sampling mode, manual mode and R-R analysis
mode.
4. Make sure that paper is installed in the USB printer before
printing. Error may occur if no paper is loaded in the USB
Printer.
CAUTION
It is forbidden to connect or disconnect a U disk, an SD card or a USB printer during the
transmission course.
Speed
Choose from: 5mm/s, 6.25mm/s, 10mm/s, 12.5mm/s, 25mm/s or
50mm/s
In the manual mode, select 5mm/s, 6.25mm/s, 10mm/s, 12.5mm/s,
25mm/s or 50mm/s.
Only 25mm/s and 50mm/s are available in the auto and rhythm modes.
Only 25mm/s is available in the R-R analysis mode.
Paper Marker
Paper Marker is used to identify the start point of each page of the
recorder paper.
Choose from: Yes or No
Select Ye s if the paper with black markers on the bottom is used, and the
device can identify the start point of each page of the recorder paper while
printing ECG reports.