Chapter 5
| SNMP Commands
– 178 –
show snmp user Shows the SNMP users PE
show snmp view Shows the SNMP views PE
Notification Log Commands
nlm Enables the specified notification log GC
snmp-server notify-filter Creates a notification log and specifies the target host GC
show nlm oper-status Shows operation status of configured notification logs PE
show snmp notify-filter Displays the configured notification logs PE
ATC Trap Commands
snmp-server enable port-
traps atc broadcast-alarm-
clear
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port)
snmp-server enable port-
traps atc broadcast-alarm-
fire
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc broadcast-control-
apply
Sends a trap when broadcast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port)
snmp-server enable port-
traps atc broadcast-control-
release
Sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
clear
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered
IC (Port)
snmp-server enable port-
traps atc multicast-alarm-
fire
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control
IC (Port)
snmp-server enable port-
traps atc multicast-control-
apply
Sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer
expires
IC (Port)
snmp-server enable port-
traps atc multicast-control-
release
Sends a trap when multicast traffic falls beneath the lower
threshold after a storm control response has been
triggered and the release timer expires
IC (Port)
Transceiver Power Threshold Trap Commands
transceiver-threshold
current
Sends a trap when the transceiver current falls outside the
specified thresholds
IC (Port)
transceiver-threshold
rx-power
Sends a trap when the power level of the received signal
falls outside the specified thresholds
IC (Port)
transceiver-threshold
temperature
Sends a trap when the transceiver temperature falls
outside the specified thresholds
IC (Port)
transceiver-threshold
tx-power
Sends a trap when the power level of the transmitted signal
power outside the specified thresholds
IC (Port)
transceiver-threshold
voltage
Sends a trap when the transceiver voltage falls outside the
specified thresholds
IC (Port)
Table 29: SNMP Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General