Chapter 6
| Remote Monitoring Commands
– 206 –
Command Usage
â—† If an event is already defined for an index, the entry must be deleted before any
changes can be made with this command.
â—† The specified events determine the action to take when an alarm triggers this
event. The response to an alarm can include logging the alarm or sending a
message to a trap manager.
Example
Console(config)#rmon event 2 log description urgent owner mike
Console(config)#
rmon collection
history
This command periodically samples statistics on a physical interface. Use the no
form to disable periodic sampling.
Syntax
rmon collection history controlEntry index
[buckets number [interval seconds]] | [interval seconds] |
[owner name [buckets number [interval seconds]]
no rmon collection history controlEntry index
index – Index to this entry. (Range: 1-65535)
number – The number of buckets requested for this entry. (Range: 1-65535)
seconds – The polling interval. (Range: 1-3600 seconds)
name – Name of the person who created this entry.
(Range: 1-32 characters)
Default Setting
1.3.6.1.2.1.16.1.1.1.6.1 - 1.3.6.1.2.1.16.1.1.1.6.28/52
Buckets: 8
Interval: 30 seconds for even numbered entries,
1800 seconds for odd numbered entries
Command Mode
Interface Configuration (Ethernet)
Command Usage
â—† By default, each index number equates to a port on the switch, but can be
changed to any number not currently in use.
â—† If periodic sampling is already enabled on an interface, the entry must be
deleted before any changes can be made with this command.
To Next Page
Loading...
Need help?
General