Chapter 26
| CFM Commands
Defining CFM Structures
– 785 –
ethernet cfm
port-enable
This command enables CFM processing on an interface. Use the no form to disable
CFM processing on an interface.
Syntax
[no] ethernet cfm port-enable
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—† An interface must be enabled before a MEP can be created with the ethernet
cfm mep command.
â—† If a MEP has been configured on an interface with the ethernet cfm mep
command, it must first be deleted before CFM can be disabled on that
interface.
â—† When CFM is disabled, hardware resources previously used for CFM processing
on that interface are released, and all CFM frames entering that interface are
forwarded as normal data traffic.
Example
This example enables CFM on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#ethernet cfm port-enable
Console(config-if)#
clear ethernet cfm
ais mpid
This command clears AIS defect information for the specified MEP.
Syntax
clear ethernet cfm ais mpid mpid md domain-name ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric characters)
ma-name – Maintenance association name. (Range: 1-43 alphanumeric
characters)
Default Setting
None
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General