Chapter 15
| Congestion Control Commands
Automatic Traffic Control Commands
– 473 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-apply
Console(config-if)#
Related Commands
auto-traffic-control alarm-fire-threshold (467)
auto-traffic-control apply-timer (463)
snmp-server
enable port-traps atc
multicast-control-
release
This command sends a trap when multicast traffic falls beneath the lower threshold
after a storm control response has been triggered and the release timer expires.
Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc multicast-control-release
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-
release
Console(config-if)#
Related Commands
auto-traffic-control alarm-clear-threshold (466)
auto-traffic-control action (465)
auto-traffic-control release-timer (464)
ATC Display Commands
show auto-traffic-
control
This command shows global configuration settings for automatic storm control.
Command Mode
Privileged Exec
Example
Console#show auto-traffic-control
Storm-control: Broadcast
Apply-timer (sec) : 300
To Next Page
Loading...
Need help?
General