Chapter 8
| Authentication Commands
802.1X Port Authentication
– 264 –
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout tx-period 300
Console(config-if)#
dot1x re-authenticate This command forces re-authentication on all ports or a specific interface.
Syntax
dot1x re-authenticate [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
Command Mode
Privileged Exec
Command Usage
The re-authentication process verifies the connected client’s user ID and password
on the RADIUS server. During re-authentication, the client remains connected the
network and the process is handled transparently by the dot1x client software.
Only if re-authentication fails is the port blocked.
Example
Console#dot1x re-authenticate
Console#
To Next Page
Loading...
Need help?
General