Chapter 5
| SNMP Commands
General SNMP Commands
– 179 –
General SNMP Commands
snmp-server This command enables the SNMPv3 engine and services for all management clients
(i.e., versions 1, 2c, 3). Use the no form to disable the server.
Syntax
[no] snmp-server
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#snmp-server
Console(config)#
Additional Trap Commands
memory Sets the rising and falling threshold for the memory
utilization alarm
GC
process cpu Sets the rising and falling threshold for the CPU utilization
alarm
GC
process cpu guard Sets the CPU utilization watermark and threshold GC
show memory Shows memory utilization parameters PE
show process cpu Shows CPU utilization parameters PE
show process cpu guard Shows the CPU utilization watermark and threshold PE
show process cpu task Shows CPU utilization per process NE, PE
Table 29: SNMP Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General