Chapter 4
| System Management Commands
Time
– 163 –
Command Mode
Global Configuration
Command Usage
â—† In some countries or regions, clocks are adjusted through the summer months
so that afternoons have more daylight and mornings have less. This is known as
Summer Time, or Daylight Savings Time (DST). Typically, clocks are adjusted
forward one hour at the start of spring and then adjusted backward in autumn.
â—† This command sets the summer-time zone relative to the currently configured
time zone. To specify a time corresponding to your local time when summer
time is in effect, you must indicate the number of minutes your summer-time
zone deviates from your regular time zone (that is, the offset).
Example
The following example sets the 2015 Summer Time ahead by 60 minutes on March
9th and returns to normal time on November 2nd.
Console(config)#clock summer-time DEST date march 9 2015 01 59 november 2
2014 01 59 60
Console(config)#
Related Commands
show sntp (157)
clock summer-time
(predefined)
This command configures the summer time (daylight savings time) status and
settings for the switch using predefined configurations for several major regions in
the world. Use the no form to disable summer time.
Syntax
clock summer-time name predefined [australia | europe | new-zealand |
usa]
no clock summer-time
name - Name of the timezone while summer time is in effect, usually an
acronym. (Range: 1-30 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
â—† In some countries or regions, clocks are adjusted through the summer months
so that afternoons have more daylight and mornings have less. This is known as
To Next Page
Loading...
Need help?
General