Edge-Core ECS4120-52T Reference Guide

Chapter 8 | Authentication Commands
AAA
– 234 –
Default Setting
Accounting is not enabled
No servers are specified
Command Mode
Global Configuration
Command Usage
◆ This command runs accounting for Exec service requests for the local console
and Telnet connections.
◆ Note that the default and method-name fields are only used to describe the
accounting method(s) configured on the specified RADIUS or TACACS+ servers,
and do not actually send any information to the servers about the methods to
use.
Example
Console(config)#aaa accounting exec default start-stop group tacacs+
Console(config)#
aaa accounting
update
This command enables the sending of periodic updates to the accounting server.
Use the no form to disable accounting updates.
Syntax
aaa accounting update [periodic interval]
no aaa accounting update
interval - Sends an interim accounting record to the server at this interval.
(Range: 1-2147483647 minutes)
Default Setting
1 minute
Command Mode
Global Configuration
Command Usage
◆ When accounting updates are enabled, the switch issues periodic interim
accounting records for all users on the system.
◆ Using the command without specifying an interim interval enables updates,
but does not change the current interval setting.

Edge-Core ECS4120-52T Specifications

General

Device Type	Managed Switch
Switching Capacity	176 Gbps
Forwarding Rate	131 Mpps
MAC Address Table Size	16K
DRAM	512 MB
Ports	48 x 10/100/1000BASE-T
Jumbo Frame Support	Up to 9KB
CPU	800MHz
Power Supply	AC 100-240V, 50-60Hz
Operating Temperature	0°C to 50°C
Storage Temperature	70 °C
Dimensions (W x D x H)	440 x 44 mm
Layer	Layer 2 / Layer 3 Lite
Humidity	10% to 90% (non-condensing)