Chapter 25
| LLDP Commands
– 761 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-notification
Console(config-if)#
lldp med-tlv ext-poe This command configures an LLDP-MED-enabled port to advertise and accept
Extended Power-over-Ethernet configuration and usage information. Use the no
form to disable this feature.
Syntax
[no] lldp med-tlv ext-poe
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises extended Power-over-Ethernet capability details, such as
power availability from the switch, and power state of the switch, including
whether the switch is operating from primary or backup power (the Endpoint
Device could use this information to decide to enter power conservation mode).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp med-tlv ext-poe
Console(config-if)#
lldp med-tlv inventory This command configures an LLDP-MED-enabled port to advertise its inventory
identification details. Use the no form to disable this feature.
Syntax
[no] lldp med-tlv inventory
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises device details useful for inventory management, such as
manufacturer, model, software version and other pertinent information.
To Next Page
Loading...
Need help?
General