Chapter 8
| Authentication Commands
TACACS+ Client
– 230 –
Default Setting
None
Command Mode
Global Configuration
Example
Console(config)#tacacs-server key green
Console(config)#
tacacs-server port This command specifies the TACACS+ server network port. Use the no form to
restore the default.
Syntax
tacacs-server port port-number
no tacacs-server port
port-number - TACACS+ server TCP port used for authentication messages.
(Range: 1-65535)
Default Setting
49
Command Mode
Global Configuration
Example
Console(config)#tacacs-server port 181
Console(config)#
tacacs-server
retransmit
This command sets the number of retries. Use the no form to restore the default.
Syntax
tacacs-server retransmit number-of-retries
no tacacs-server retransmit
number-of-retries - Number of times the switch will try to authenticate
logon access via the TACACS+ server. (Range: 1 - 30)
Default Setting
2
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General