Chapter 5
| SNMP Commands
SNMPv3 Commands
– 192 –
Console(config)#snmp-server view ifEntry.2 1.3.6.1.2.1.2.2.1.*.2 included
Console(config)#
This view includes the MIB-2 interfaces table, and the mask selects all index entries.
Console(config)#snmp-server view ifEntry.a 1.3.6.1.2.1.2.2.1.1.* included
Console(config)#
show snmp engine-id This command shows the SNMP engine ID.
Command Mode
Privileged Exec
Example
This example shows the default engine ID.
Console#show snmp engine-id
Local SNMP Engine ID : 8000018403FC0A81B7C7E00000
Local SNMP Engine Boots : 29
Remote SNMP EngineID IP address
80000000030004e2b316c54321 192.168.1.19
Console#
show snmp group Four default groups are provided – SNMPv1 read-only access and read/write access,
and SNMPv2c read-only access and read/write access.
Command Mode
Privileged Exec
Example
Console#show snmp group
Group Name: r&d
Security Model: v3
Table 30: show snmp engine-id - display description
Field Description
Local SNMP engineID String identifying the engine ID.
Local SNMP engineBoots The number of times that the engine has (re-)initialized since the snmp
EngineID was last configured.
Remote SNMP engineID String identifying an engine ID on a remote device.
IP address IP address of the device containing the corresponding remote SNMP
engine.
To Next Page
Loading...
Need help?
General