EasyManuals Logo

Elmo EL65R2 User Manual

Elmo EL65R2
89 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
A product and cart combination should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause
the product and cart combination to overturn.
Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you
to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
Safety Check - Upon completion of any service or repairs to this product, ask the service technician
to perform safety checks to determine that The product is in proper operating condition.
Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves,
or other products (including amplifiers) that produce heat.
IMPORTANT
The following are the normal operating requirements for the display (not including OPS):
MODEL Power requirements
EL55R2 AC100V240V 300W max
EL65R2 AC100V240V 300W max
EL75R2 AC100V240V 330W max
EL86R2 AC100V240V 450W max
For additional requirements and other information, refer to the display’s specifications.
Federal Communication Commission interference statement
FCC
Suppliers Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier: EL55R2, EL65R2, EL75R2, EL86R2
Responsible Party U.S. Contact Information
ELMO USA CORP.
6851 Jericho Turnpike, Suite 145
Syosset, NY 11791
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules.These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate this equipment.
Restriction
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
IEEE 802.11b or 802.11g operation of this product in the USA is firmware limited to channels 1 through 13.
CAUTION
i. the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference
to co-channel mobile satellite systems;
ii. the maximum antenna gain permitted for devices in the bands 5250 -5350 MHz and 5470-5725 MHz shall comply with the
e.i.r.p. limit; and
iii. the maximum antenna gain permitted for devices in the band 5725 -5825 MHz shall comply with the e.i.r.p. limits
specified for point-to-point and non point-to-point operation as appropriate.
iv. Users should also be advised that high-power radars are allocated as primary users (i.e., priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE -LAN devices.
Radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance of 20 cm between the antenna of this device and
all nearby persons.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
EU declaration of conformity
Hereby TECHNO HORIZON CO., LTD. declares that the radio equipment type Interactive displays model EL55R 2, EL65R2,
EL75R2, EL86R2 are in compliance with directive 2014/53/EU.
WARNING
Operation of this equipment in a residential environment this equipment may could cause radio interference.
The frequency band and the maximum transmitted power in EU are listed below:
Transmitting Band (MHz) 2402-2483.5 5150-5350 5470-5725
Maximum Transmit Power EIRP (dBm) 19 23 23

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elmo EL65R2 and is the answer not in the manual?

Elmo EL65R2 Specifications

General IconGeneral
BrandElmo
ModelEL65R2
CategoryProjector
LanguageEnglish

Related product manuals