Elmo L-12W - Selecting the Image Source; Pausing the Image

24
BASIC
OPERATIONS

Selecting the image source
You can select the image source as described
below.
Camera image：
[ ] button on the operating panel or [ ] button on the
remote control.
Image being input to the ［ / ］ port：
[ ] button on the operating panel or [ ] button on the
remote control.
Image stored in SD card/USB ash drive：
[ ] button on the operating panel or [ ] button on the
remote control.
• When using a computer with an external output mode, set the computer to the external
output mode after pressing the [ ] button on the operating panel or the [ ] button
on the remote control.
• When the [ ] button on the operating panel or the [ ] button on the remote control is
pressed, the image being input to the [ ] port will only be output from the [ ]
port and the image being input to the [ ] port will only be output from the [ ]
port.

Pausing the image
Press the [ ] button on the operating panel or the [ ] button on the remote
control to pause the camera image. Press the button again to cancel the p
RC
-
VL
Note