EasyManuals Logo

Elmo L-12W User Manual

Elmo L-12W
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
vi
BEFORE YOU USE
When using this device, be sure to use the supplied power cord and AC adapter.
The power cord and AC adapter that come with this product are for this product only. Do not use
them with another product.
Be sure to use the power cord applicable to your local power specifications.
When storing the product, do not leave it under direct sunlight or by heaters. It may become
discolored, deformed, or damaged.
Do not place this product in any humid, dusty, salt bearing wind, or vibrating locations.
Only use it under the following environmental conditions:
Temperature: 0°C - 40°C (32°F - 104°F)
Humidity:30% - 85% (No condensation)
Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
Do not point the camera lens directly at the sun. It may be damaged and you may not be able to
take pictures.
Luminescent and Black Spots
There may be some pixels that do not properly operate due to the use of CMOS Area Image Sensors
made-up of many pixels.
Though luminescent or black spots may be found on the screen, it is a phenomenon peculiar to the
CMOS Area Image Sensors and is not a malfunction.
Follow the guidelines below to prevent the unit from dropping or overturning.
Use the product on a stable base, desk, or table. Do not place the product on an unstable base or
slanted surface.
Place or wire the unit to prevent the AC adapter cord or video cable from pulling.
Carry the product by holding the lower part of the main unit in both hands. Never hold the product
by the column or the camera head.
Pay careful attention when using (including setting-up and storing) or transferring the product to
prevent the camera head from receiving any shocks.
Do not look directly into the LED light. If you look directly into it at point-blank range, your eyes
may be injured.
Some type of SD card/USB flash drive can be used.
Transfer the data from the SD card onto a device such as a PC to save a backup copy. Malfunction of
the product or repairs to it may cause the data saved in the SD card to be deleted.
If this product is used for longer than the warranty period, its performance and quality may
deteriorate due to the lifetime of its parts. To purchase replacement parts, consult the dealer from
whom you purchased this product or our branch/office near your location.
Battery precautions:
If this product is not going to be used for a long time, take the batteries out of the remote control.
Do not use rechargeable batteries.
Do not use new and old batteries or batteries of different types together.
Do not try to recharge or short-circuit the batteries.
When disposing of used batteries, follow the instructions of your local government.
Insert from one side and pay particular attention to the polarity (+/- directions).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elmo L-12W and is the answer not in the manual?

Elmo L-12W Specifications

General IconGeneral
AC input voltage100 - 240 V
Operating voltage12 V
Power supply typeDC
Power consumption (typical)5 W
InterfaceUSB 2.0
DC-in jackYes
Wi-Fi standards802.11a, 802.11b, 802.11g, Wi-Fi 4 (802.11n)
USB connector typeUSB Type-A, USB Type-B
VGA (D-Sub) input ports1
Lamp typeLED
Product colorWhite
Image formats supportedJPG
Maximum operating distance0.2 m
Compatible memory cardsSD
Sensor typeCMOS
Maximum frame rate30 fps
Effective sensor resolution6.7 MP
Supported graphics resolutions2992 x 2244, 3264 x 2448
Digital zoom16 x
Optical zoom12 x
Shooting area (WxD)470 x 260 mm
Maximum focal length (f)3.6 mm
Quantity per pack1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth377 mm
Width349 mm
Height432 mm
Weight3000 g
Dimensions folded (WxDxH)195 x 294 x 475 mm

Related product manuals