Install and Configure EMC NAS Software
135
EMC CONFIDENTIAL
9
The VNX VG2/VG8 gateway blades boot from the array. You must install the EMC
NAS software on the array and configure the Fibre Channel (FC) or Fibre Channel
over Ethernet (FCoE) switch to enable the blades to connect to the array:
◆ Step 1: Power up the VNX gateway system............................................................ 136
◆ Step 2: Install latest File OE on CS 0 ......................................................................... 139
◆ Step 3: Install latest File OE on CS 1 ......................................................................... 141
◆ Step 4: Configure ConnectHome .............................................................................. 142
◆ Step 5: Check system status ....................................................................................... 143
◆ Step 6: Enable licensed features ................................................................................ 143
◆ Step 7: Complete the hand-off worksheet ............................................................... 144
◆ Step 8: Final configuration ......................................................................................... 144
Install and Configure
EMC NAS Software
To Next Page
Loading...