EMC VNX VG2 - Page 184

EMC VNX VG2/VG8 Gateway Configuration Setup Guide
184
Change IP Addresses
EMC CONFIDENTIAL
30. If the system output in step 29 includes a reason code of 10, run this command:
# ls /nasmcd/.nas_service_status
Example output (services not yet started):
# ls /nasmcd/.nas_service_status
/nasmcd/.nas_service_status
Example output (services started):
# ls /nasmcd/.nas_service_status
ls: /nasmcd/.nas_service_status: No such file or directory
If the file exists, NAS services have started.
31. Check the VG2/VG8 system status by using the nas_checkup command:
# /nas/bin/nas_checkup