1019567 REV. 03 21
This multi-turn control is calibrated in color rings, visible in slots.
3 Down Speed Control
Controls rate of carriage descent, multi-turn
color coded, each turn calibrated at 0-9. Pull red
locking ring to set; push locking ring to lock.
Return rate is fixed.
4 Autotune Label
Refer to 6.1.4 Manual Tuning of your Operating
Manual.
5 Front Panel Displays Refer to next section.
6 Stroke Indicator
Provides a quick method of determining relative
carriage travel during a weld cycle; indicates 0 -
4 in. (0 - 100 mm)
7 Trigger Pressure Control
Selects dynamic triggering pressure; calibrated
1-24 in half-steps/48 detents corresponding to a
force range of 15-200 lbs/67-890 N.
8 Carriage Door
Provides access to the converter-booster-horn
stack; secured by 4 captive hex screws.
9
Mechanical Stop Locking
Nut
Locks the mechanical stop to desired depth.
10 Mechanical Stop
Limits the distance the carriage travels to
prevent the horn from contacting the fixture or
nest when no workpiece is in place; adjustment
is approximately 0.04 in/1 mm per rotation.
Table 2.1 Front Panel Controls
Item Name Function
To Next Page
Loading...
