Emerson Aventics G3 Series - RTD Module: Alarm Settings Configuration

G3 Series EtherCAT
TM
Technical Manual
11-110
TDG3ECM1-5EN 07/2020
Subject to change without notice
www.asco.com/g3
RTD Module / Alarm Settings
Allows the Low and High alarms of each RTD Input channel to be set. This parameter
generates a visual and logical (bit) when set value is achieved.
A) Press the SET button to enter the
Alarm Settings sub-menu.
B) Press the NEXT button to scroll
through the RTD Input channels.
C) Press the SET button to enter the
alarm setting for the selected Input
channel.
D) Press the NEXT button to select the Lo
or High setting for the selected
channel.
E) Press the SET button to select the
change process for the chosen alarm.
The first digit/sign will be highlighted.
F) Press the NEXT button to choose the
value, or the SET button to select and
move to the next digit.
G) Press the NEXT button to choose “Y”
or “N” Select. Then press the SET
Button to Accept.
NOTE!
SET ALARM
CHANNEL CH0
SET ALRM CH1
LO = -200.0 C
SET ALRM CH1
LO = -200.0 C
ACCEPT
50.0 C Y N
ALARM
SETTINGS
• When alarm values are set to maximum/minimum values, the
alarm function is disabled.
• Factory default settings for all alarms are disabled.