G3 Series EtherCAT
TM
Technical Manual
13-137
Subject to change without notice
www.asco.com/g3
Node Configuration
The “Node Configuration” window can be used to control different parameters within the manifold. These parameters
include, “Station Alias”, “Max Coils”, “Node Configuration Parameters (lock)” and “I/O Configuration (lock)”.
Once the changes have been made, left click on the “Update Configuration” button. The “Configuration Successfully
Updated” window will appear. The EtherCAT
TM
node will reset in a few seconds, or the user may cycle power to enable
the new configuration.
To Next Page
Loading...
