G3 Series EtherCAT
TM
Technical Manual
13-138
Subject to change without notice
www.asco.com/g3
Password
The “Password” window allows the user to set a password that will prevent unwanted access to the I/O Force and Test
functionality. The password comes disabled from the factory. To set the initial password, leave the “Enter Current
Password” field blank and type in the new password in the “Enter New Password” field.
Once a Password has been set, the security check screen will appear when accessing Diagnostic or Node Configuration
parameters.
• If the password has been lost or forgotten, go through the process of
changing the password. Enter the last 6 digits of the MAC Address in the
current password field and then enter the desired password in the new
password field.
To Next Page
Loading...
