Emerson E300 Series - Page 125

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu
A
Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 125
Issue Number: 1
A46
V4 Speed
Reference
{G04} 0 to Nominal Elevator Speed (A28) 10 mm/s RW Num US
A47
Brake Control
Release Delay
{D04} 0 to 10000 ms 500 ms RW Num US
A48
Brake Control Apply
Delay
{D05} 0 to 10000 ms 500 ms RW Num US
A49
Start Speed Loop P
Gain
{I01}
0.0000 to 200.0000 s/rad 0.0300 s/rad RW Num US
A50
Start Speed Loop I
Gain
{I02}
0.00 to 655.35 s
2
/rad 0.10 s
2
/rad
RW Num US
A51
Start Current Loop
Filter
{I05}
0.0 to 25.0 ms 1.0 ms RW Num US
A52
Run Speed Loop P
Gain
{I06}
0.0000 to 200.0000 s/rad 0.0300 s/rad RW Num US
A53
Run Speed Loop I
Gain
{I07}
0.00 to 655.35 s
2
/rad 0.10 s
2
/rad
RW Num US
A54
Run Current Loop
Filter
{I10}
0.0 to 25.0 ms 1.0 ms RW Num US
A55 Start Lock Enable {I22}
Off (0) or On (1) Off (0) RW Bit US
A56
Start Lock P Gain
Speed Clamp
{I21}
0 to 10000 mm/s 100 mm/s RW Num US
A57 Start Lock P Gain {I20}
0.000 to 1000.000 50.000 RW Num US
A58 Start Optimizer Time {G48}
0 to 10000 ms 1000 ms RW Num US
A59 Start Optimizer Jerk {G47}
±VM_EX00_RUN_JERK_
1 mm/s
3
x 10
10 mm/s
3
x 10
RW Num US
A60
Start Optimizer
Speed
{G46} 0 to 10000 mm/s
50
mm/s
10 mm/s RW Num US
A61
Start Optimizer
Enable
{G45}
Off (0) or On (1) Off (0) RW Bit US
A62
to
A80
User Menu A
Parameters Set-up
Using Menu Z
RW Read / Write RO Read only Num Number parameter Bit Bit parameter Txt Text string Bin Binary parameter FI Filtered
ND No default value NC Not copied PT Protected parameter RA Rating dependent US User save PS Power-down save DE Destination
IP IP address Mac Mac address Date Date parameter Time Time parameter
Parameter
Range(Ú)Default(Ö)
Type
OL RFC-A RFC-S OL RFC-A RFC-S