Emerson E300 Series - Page 124

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu
A
Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
124 E300 Design Guide
Issue Number: 1
A21
Motor Rated
Frequency
{B06} 0.0 to 550.0 Hz
50 Hz: 50.0
60 Hz: 60.0
RW Num US
A22 Motor Rated Speed {B07} 0 to 33000 rpm
0.00 to
33000.00 rpm
50 Hz:
1500.0
rpm,
60 Hz:
1800.0
rpm
50 Hz:
1450.00
rpm
60 Hz:
1750.00
rpm
3000.00
rpm
RW Num US
A23
Open Loop Control
Mode
{B09}
Ur S (0), Ur (1),
Fixed (2),
Ur Auto (3),
Ur I (4)
Ur I (4) RW Txt US
RFC: Action On
Enable
{B09}
Disabled (0),
Short (1),
Short Once
(2), Long (3),
Long Once (4)
Disabled
(0)
RW Txt US
A24
Symmetrical Current
Limit
{B16} ± VM_MOTOR1_CURRENT_LIMIT % 165.0 % 175.0 % RW Num RA US
A25
Maximum Switching
Frequency
{B13}
2 kHz (0), 3 kHz (1), 4 kHz (2), 6 kHz (3),
8 kHz (4) 12 kHz (5), 16 kHz (6)
8 kHz (4) RW Txt RA US
A26 Motor Autotune {B11}
None (0), Static
(1), Rotating (2)
None (0), Static (1),
Rotating (2), Inertia (3)
None (0) RW Txt NC US
A27
Reverse Motor
Phase Sequence
{B26} Off (0) or On (1) 0ff (0) RW Bit US
A28
Nominal Elevator
Speed mm/s
{E01} 0 to 1800 mm/s 0 to 4000 mm/s 1000 mm/s RW Num US
A29 Sheave Diameter {E02} 1 to 32,767 mm 400 mm 480 mm RW Num US
A30 Roping {E03} 1:1 (1), 2:1 (2), 3:1 (3), 4:1 (4) 1:1 (1) RW Txt US
A31
Gear Ratio
Numerator
{E04} 1 to 32767 31 1 RW Num US
A32
Gear Ratio
Denominator
{E05} 1 to 32767 1 RW Num US
A33
Nominal Elevator
Speed Rpm
{E07} 1.00 to 4000.00 rpm 1480.14 rpm
39.48
rpm
RW Num US
A34
Motor Maximum
Frequency Clamp
{E08}
-214748364.8 to 214748364.7
54.8 Hz
RO Num US
Motor Maximum
Speed Clamp
{E08}
1644.6
rpm
43.8 rpm RO Num US
A35 Run Jerk 1 {G13} 1 to 65535 mm/s³ x10 50 mm/s³ x10 RW Num US
A36 Run Jerk 2 {G14} 1 to 65535 mm/s³ x10 100 mm/s³ x10 RW Num US
A37 Run Jerk 3 {G15} 1 to 65535 mm/s³ x10 100 mm/s³ x10 RW Num US
A38 Run Jerk 4 {G16} 1 to 65535 mm/s³ x10 50 mm/s³ x10 RW Num US
A39 Creep Stop Jerk {G18} 1 to 65535 mm/s³ x10 100 mm/s³ x10 RW Num US
A40 Acceleration Rate {G11} 0 to 10000 mm/s² 800 mm/s² RW Num US
A41 Deceleration Rate {G12} 0 to 10000 mm/s² 500 mm/s² RW Num US
A42
Creep Stop
Deceleration Rate
{G17} 0 to 10000 mm/s² 1000 mm/s² RW Num US
A43
V1 Speed
Reference
{G01} 0 to Nominal Elevator Speed (A28) 50 mm/s RW Num US
A44
V2 Speed
Reference
{G02} 0 to Nominal Elevator Speed (A28) 400 mm/s RW Num US
A45
V3 Speed
Reference
{G03} 0 to Nominal Elevator Speed (A28) 600 mm/s RW Num US
Parameter
Range(Ú) Default(Ö)
Type
OL RFC-A RFC-S OL RFC-A RFC-S