Emerson E300 Series - Page 396

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
396 E300 Design Guide
Issue Number: 1
5. Percentage Of Drive Thermal Trip Level (J79) = 100 %. This is an indication that some part of the drive is too hot and is used to indicate if an
internally installed braking resistor is too hot.
6. Brake R Too Hot is active or the system has been set up to disable the braking IGBT based on the braking resistor temperature and the resistor
is too hot (i.e. bit 2 of Action On Trip Detection (H45) is set).
See Trip 0 (L29).
See Trip 0 (L29).
See Trip 0 (L29).
See Trip 0 (L29).
See Trip 0 (L29).
L30 Trip 1
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 255
Default Units
Type 8 Bit Power Down Save Update Rate Write on trip
Display Format Standard Decimal Places 0
Coding RO, TE, ND, NC, PT, BU
L31 Trip 2
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 255
Default Units
Type 8 Bit Power Down Save Update Rate Write on trip
Display Format Standard Decimal Places 0
Coding RO, TE, ND, NC, PT, BU
L32 Trip 3
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 255
Default Units
Type 8 Bit Power Down Save Update Rate Write on trip
Display Format Standard Decimal Places 0
Coding RO, TE, ND, NC, PT, BU
L33 Trip 4
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 255
Default Units
Type 8 Bit Power Down Save Update Rate Write on trip
Display Format Standard Decimal Places 0
Coding RO, TE, ND, NC, PT, BU
L34 Trip 5
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 255
Default Units
Type 8 Bit Power Down Save Update Rate Write on trip
Display Format Standard Decimal Places 0
Coding RO, TE, ND, NC, PT, BU