Emerson E300 Series - Page 398

Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
398 E300 Design Guide
Issue Number: 1
A 0 to 1 transition in Drive Reset (L40) causes a drive reset. If a drive reset terminal is required a digital input should be routed to Drive Reset (L40).
See Trip 0 (L29).
See Trip 0 (L29).
See Trip 0 (L29).
See Trip 0 (L29).
L40 Drive Reset
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate Background read
Display Format Standard Decimal Places 0
Coding RW, NC
L41 Trip 0 Date
Mode Open-Loop, RFC-A, RFC-S
Minimum
0
(Display: 00-00-00)
Maximum
311299
(Display: 31-12-99)
Default Units
Type 32 Bit Power Down Save Update Rate Write on trip
Display Format Date Decimal Places 0
Coding RO, ND, NC, PT
L42 Trip 0 Time
Mode Open-Loop, RFC-A, RFC-S
Minimum
0
(Display: 00-00-00)
Maximum
235959
(Display: 23:59:59)
Default Units
Type 32 Bit Power Down Save Update Rate Write on trip
Display Format Time Decimal Places 0
Coding RO, ND, NC, PT
L43 Trip 1 Date
Mode Open-Loop, RFC-A, RFC-S
Minimum
0
(Display: 00-00-00)
Maximum
311299
(Display: 31-12-99)
Default Units
Type 32 Bit Power Down Save Update Rate Write on trip
Display Format Date Decimal Places 0
Coding RO, ND, NC, PT
L44 Trip 1 Time
Mode Open-Loop, RFC-A, RFC-S
Minimum
0
(Display: 00-00-00)
Maximum
235959
(Display: 23:59:59)
Default Units
Type 32 Bit Power Down Save Update Rate Write on trip
Display Format Time Decimal Places 0
Coding RO, ND, NC, PT