64 Operation via the Control Panel CG Drives & Automation 01-7318-01r1
9.9 Programming example
This example shows how to program a change of Language
from English (default) to Nederlands.
The flashing cursor indicates that a change has taken place
but is not saved yet. If at this moment, the power fails, the
change will not be saved.
Use the ESC, Prev, Next or the Toggle keys to proceed and
to go to other menus.
Fig. 65 Programming example
Menu 100 appears
after power-up.
or
Press “Next” key for
menu [200].
or
Press “Enter” key for
menu [210].
or
Press “Enter” key for
menu [211].
or
Press “+” key
Keep key pressed
until desired lan-
guage has been
reached.
or
Save the changed
value by pressing
“Enter” key.
Save the selected lan-
guage by pressing
Enter.
211 Language
Stp Nederlands
211 Language
Stp Nederlands
To Next Page
Loading...
Need help?
General