Identification Cubemass DCI MODBUS RS485
10 Endress+Hauser
2.1.4 Additional sign – position of the rupture disk
A0011967
Fig. 4: Additional sign regarding the position of the rupture disk (RUPTURE DISK)
A Sensor housing with rupture element (incl. rupture disk) È defined fluid exit
A Sensor housing with rupture disk È undefined fluid exit
!
Note!
Additional information on the burst pressure of the secondary containment → ä 90.
2.2 Certificates and approvals
The devices are designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, have been tested, and left the factory in a condition in which they are safe to
operate.
The measuring devices comply with the applicable standards and regulations in accordance with
EN 61010 -1, "Safety requirements for electrical equipment for measurement, control and
laboratory use" and with the EMC requirements of IEC/EN 61326.
The measuring system described in these Operating Instructions thus complies with the statutory
requirements of the EC Directives. Endress+Hauser confirms successful testing of the device by
affixing to it the CE mark.
The measuring system meets the EMC requirements of the Australian Communications and Media
Authority (ACMA).
The measuring device meets all the requirements of the MODBUS/TCP conformity and integration
test and holds the "MODBUS/TCP Conformance Test Policy, Version 2.0". The measuring device
has successfully passed all the test procedures carried out and is certified by the "MODBUS/TCP
Conformance Test Laboratory" of the University of Michigan.
2.3 Registered trademarks
MODBUS
®
Registered trademark of the MODBUS Organization
HistoROM™, S-DAT
®
, T-DAT™, FieldCare
®
, Fieldcheck
®
, Applicator
®
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH
RUPTURE DISK
12.5BAR+/-10%@80°C
i
RUPTURE DISK
12.5BAR+/-20%@20°C
i
A
B
To Next Page
Loading...
