Endress+Hauser Cubemass DCI - 5 Operation; 5.1 Display and operating elements

Operation Cubemass DCI MODBUS RS485
26 Endress+Hauser
5Operation
5.1 Display and operating elements
The local display enables you to read all important parameters directly at the measuring point and
configure the device using the "Quick Setup" or the function matrix.
The display consists of four lines; this is where measured values and/or status variables (direction
of flow, empty pipe, bar graph etc.) are displayed. You can change the assignment of display lines to
different variables to suit your needs and preferences (È "Description of Device Parameters"
manual, GP003D/06/).
A0001172
Fig. 16: Display and operating elements
1 Liquid crystal display
The backlit, four-line liquid crystal display shows measured values, dialog texts, fault messages and notice
messages. HOME position (operating mode) is the term given to the display during normal operation.
Readings displayed
2 Optical sensors for "Touch Control"
3 Plus/minus keys
–HOME position → Direct access to totalizer values and actual values of inputs/outputs
– Enter numerical values, select parameters
– Select different blocks, groups and function groups within the function matrix
Press the +/- keys ( X) simultaneously to trigger the following functions:
– Exit the function matrix step by step → HOME position
– Press and hold the Q keys for longer than 3 seconds → Return directly to home position
– Cancel data entry
4 Enter key
–HOME position→ Entry into the function matrix
– Save the numerical values you input or settings you change
+24.502
+1863.97
x
y
–50
+50
%
v
v
3
S
Esc
E
+
-
1
2
34
x
y
+24.502
+1863.97
x
y
–50
+50
%
v
v
3
S
x
y