Cubemass DCI MODBUS RS485 Installation
Endress+Hauser 15
3.3 Installation instructions
3.3.1 Turning the transmitter housing
Turning the aluminum field housing
#
Warning!
The turning mechanism in devices with EEx d/de or NEC/CEC Cl. I Div. 1 classification is not the
same as that described here. The procedure for turning these housings is described in the Ex-specific
documentation.
1. Loosen the two securing screws.
2. Turn the bayonet catch as far as it will go.
3. Carefully lift the transmitter housing as far as it will go.
4. Turn the transmitter housing to the desired position (max. 2 × 90° in either direction).
5. Lower the housing into position and reengage the bayonet catch.
6. Retighten the two securing screws.
A0004302
Fig. 8: Turning the transmitter housing (aluminum field housing)
3
5
6
1
2
4
To Next Page
Loading...
