Cubemass DCI MODBUS RS485 Identification
Endress+Hauser 7
2 Identification
2.1 Device designation
The "Cubemass DCI" flow measuring system consists of the following components:
• Transmitter
•Sensor
Two versions are available:
• Compact version: transmitter and sensor form a single mechanical unit.
• Remote version: transmitter and sensor are installed separately.
2.1.1 Nameplate of the transmitter
A0011968
Fig. 1: Nameplate specifications for the transmitter (example)
1 Order code/serial number: See the specifications on the order confirmation for the meanings of the individual
letters and digits
2 Power supply/ frequency: 85 to 260 V AC/ 50 to 60 Hz
Power consumption: 15 VA / 15 W
3 Available inputs / outputs
4Reserved for information on special products
5 Ambient temperature range
6 Degree of protection
1
2
3
4
6
5
Cubemass DCI
-20°C (-4°F) <Tamb<+60°C (+140°F)
IP67 / NEMA/Type 4XOrder Code:
Ser.No.:
Ident No.:
8CN04-XXXXXXXXXXXX
XXXXXXXXXXX
85-260VAC
50-60Hz
MODBUS RS485, STATUS-IN
15VA/W
Um = 260VAC
f-OUT, I-OUT
N12895
Ta+20°C/36°F
To Next Page
Loading...
