Endress+Hauser Cubemass DCI - Nameplate for Connections

Cubemass DCI MODBUS RS485 Identification
Endress+Hauser 9
2.1.3 Nameplate for connections
A0004362
Fig. 3: Nameplate specifications for transmitter connections (example)
1 Serial number
2 Possible configuration of current output
3 Possible configuration of relay contacts
4 Terminal assignment, cable for power supply: 85 to 260 V AC, 20 to 55 V AC, 16 to 62 V DC
– Terminal No. 1: L1 for AC, L+ for DC
– Terminal No. 2: N for AC, L- for DC
5 Signals present at inputs and outputs, possible configuration and terminal assignment (20 to 27), also "Electrical
values of inputs/outputs" → ä 83
6 Version of device software currently installed (incl. language group)
7 Installed communication type
8 Information on current communication software (Device Revision and Device Description)
9 Date of installation
10 Current updates to data specified in points 6 to 9
26(+) / 27(-)
NC:
Versorgung /
Tension d'alimentation
Observer manuel d'instruction
See operating manual
Betriebsanleitung beachten
Communication:
Drivers:
Device SW: XX.XX.XX
XXXXXXXXXXXXXXXX
XXXXXXXXXXXSer.No.:
Supply /
24(+) / 25(-)
22(+) / 23(-)
20(+) / 21(-)
N/L-
PE
A:
NO:
P:
L1/L+
12
319475-00XX
active
passive
normally open contact
normally closed contact
Date: 01. MAI 2009
Update 1
Ex works / ab Werk / réglages usine
Update 2
(WEA)
26 = B (RxD/TxD-P)
27 = A (RxD/TxD-N)
3…30VDC, Ri = 3 kOhm
STATUS-IN
MODBUS RS485
X
X
max. 30VAC/0.5A
max. 60VDC/0.1A
max. 30VAC/0.5A
max. 60VDC/0.1A
RELAY
RELAY
NO
NC
2
3
10
6
7
8
9
5
4
1