Endress+Hauser Cubemass DCI - 5.2 Brief guide to the function matrix

Cubemass DCI MODBUS RS485 Operation
Endress+Hauser 29
5.2 Brief guide to the function matrix
!
Note!
• See the general notes → ä 30
• Function descriptions → see the "Description of Device Parameters" manual
1. HOME position → F → Entry into the function matrix
2. Select a block (e.g. OUTPUTS)
3. Select a group (e.g. CURRENT OUTPUT 1)
4. Select a function group (e.g. SETTINGS)
5. Select a function (e.g. TIME CONSTANT)
Change parameter / enter numerical values:
P → Select or enter enable code, parameters, numerical values
F → Save your entries
6. Exit the function matrix:
– Press and hold down Esc key (X) for longer than 3 seconds → HOME position
– Repeatedly press Esc key (X) → Return step by step to HOME position
A0001210
Fig. 18: Selecting functions and configuring parameters (function matrix)
-
+
E
Esc
>3s
E
E
E
E
E E E E E E E
–
+
–
+
–
E
+
Esc
–
+
–
+
–
+
–
+
Esc
–
m
op
q
r
n
+