Endress+Hauser Proline Promass 83 - Nameplate for Connections

Proline Promass 83 PROFIBUS DP/PA Identification
Endress+Hauser 13
2.1.3 Nameplate for connections
a0002256
Fig. 4: Nameplate specifications for Proline sensor (example)
1 Serial number
2 Possible configuration of current output
3 Possible configuration of relay contacts
4 Terminal assignment, cable for power supply: 85...260 V AC, 20...55 V AC, 16...62 V DC
Terminal No. 1: L1 for AC, L+ for DC
Terminal No. 2: N for AC, L- for DC
5 Signals present at inputs and outputs, possible configuration and terminal assignment (20...27), see also “Electrical
values of inputs/outputs”
6 Version of device software currently installed
7 Installed communication type
8 PROFIBUS ID No.
9 Date of installation
10 Current updates to data specified in points 6 to 9
Communication:
Revision:
Device SW:
ID 1529 (HEX)
3.00.02
PROFIBUS DP
Date:
01.MAR.05
SW-version
Ex-works
26(+) / 27(-)
NC:
Versorgung /
Tension d'alimentation
Observer manuel d'instruction
See operating manual
Betriebsanleitung beachten
12345678912 Ser.No.:
Supply /
24(+) / 25(-)
22(+) / 23(-)
20(+) / 21(-)
N/L-
PE
A:
NO:
P:
L1/L+
12
319475-00XX
X
P
active
passive
normally open contact
normally closed contact
X
X
Update 1 Update 2
2
3
1
4
5
6
7
8
9
10
max. 30 VAC / 0.5 A
max. 60 VDC / 0.1 A
max. 30 VAC / 0.5 A
3...30 VDC, Ri = 3 kOhm
max. 60 VDC / 0.1 A
STATUS–IN
RELAY
RELAY
26 = A (RS485)
27 = B (RS485)
PROFIBUS DP