Endress+Hauser Proline Promass 83 - Group ADVANCED DIAGNOSTICS

Commissioning Proline Promass 83 PROFIBUS DP/PA
72 Endress+Hauser
6.3.6 Data back-up with “T-DAT SAVE/LOAD”
The “T-DAT SAVE/LOAD” function can be used to store all the settings and parameters of the
device to the T-DAT data storage device.
a0001221–en
Fig. 42: Data back-up with “T–DAT SAVE/LOAD” function
Options
LOAD
Data on the T–DAT data storage device are copied to the device memory (EEPROM).
This overwrites any settings and parameters of the device.
The measuring device is restarted.
SAVE
Settings and parameters are copied from the device memory (EEPROM) to the T–DAT.
CANCEL
Cancels the option selection and returns you to the higher selection level.
Application examples
• After commissioning, the current measuring point parameters can be saved to the T-DAT as a
backup.
• If the transmitter is replaced for some reason, the data from the T-DAT can be loaded into the
new transmitter -(EEPROM).
!
Note!
• If the target device has an older software version, the message “TRANSM. SW-DAT” is displayed
during start-up. Then only the “SAVE” function is available.
•LOAD
This function is only possible if the target device has the same software version as, or a more
recent software version than, the source device.
•SAVE
This function is always available.
+
+
E
+
E
B
QUICK SETUP
1009
HOME-POSITION
Esc
E
+
-
XXX.XXX.XX
T-DAT
SAVE/LOAD
SAVE
LOAD CANCEL
YES
NO
Sure?
YES
NOSure?
Input
is saved
Restart
of the
measuring device