Proline Promass 83 PROFIBUS DP/PA Commissioning
Endress+Hauser 71
!
Note!
The parameters described in the table can be found in the “QS COMMUNICATION” group of the
“QUICK SETUP” block in the function matrix (see separate “Description of Device Functions”
manual)
6141 SET UNIT TO BUS In this function, the transmission of the configured system units to
the automation system can be enabled. By pressing the F key, the
measured values and the set system units are transmitted to the
automation system.
The options available are “OFF” and “SET UNITS”
!
Note!
When transmission takes place, the OUT value in the Analog
Input Block is automatically scaled to the set system unit and the
OUT unit (output unit) is displayed in the OUT_UNIT parameter.
The preset system units are listed in the Operating Instructions for
Promass 83 (PROFIBUS DP/PA), BA063D.
"
Caution!
Activating this function can cause the OUT output value to change
suddenly; this, in turn, can affect subsequent control routines.
Back to the HOME position:
→ Press and hold down Esc key X for longer than three seconds or
→ Repeatedly press and release Esc key X → Exit the function matrix step by step
Communication” Quick Setup.
To Next Page
Loading...
