Endress+Hauser Proline Promass 83 - Display (Operating Mode); Additional Display Functions

Proline Promass 83 PROFIBUS DP/PA Operation
Endress+Hauser 41
5.2.2 Display (operating mode)
The display area consists of three lines in all; this is where measured values are displayed, and/or
status variables (direction of flow, bar graph, etc.). You can change the assignment of display lines
to different variables to suit your needs and preferences (→ see the “Description of Device
Functions” manual).
Multiplex mode:
A maximum of two different display variables can be assigned to each line. Variables multiplexed in
this way alternate every 10 seconds on the display.
Error messages:
Display and presentation of system/process errors → Page 47
a0001173
Fig. 25: Typical display for normal operating mode (HOME position)
1 Main display line: shows primary measured values, e.g. mass flow in [kg/h]
2 Additional line: shows measured variables and status variables, e.g. totalizer No. 3 in [t]
3 Information line: shows additional information on the measured variables and status variables,
e.g. bargraph display of the full scale value achieved by the mass flow
4 “Info icons” field: icons representing additional information on the measured values are shown in this field. For a
full list of the icons and their meanings see
5 “Measured values” field: the current measured values appear in this field
6 “Unit of measure” field: the units of measure and time defined for the current measured values appear in this field
5.2.3 Additional display functions
Depending on the order options, the local display has different display functions.
Device without batching software:
From HOME position, use the +/– keys to open an “Info Menu” containing the following
information:
• Totalizer (including overflow)
• Actual values or states of the configured inputs/outputs
• Device TAG number (user-definable)
P → Scan of individual values within the Info Menu
X (Esc key) → Back to HOME position
Device with batching software:
On measuring instruments with installed batching software (F-Chip*) and a suitably configured
display line, you can carry out filling processes directly using the local display.
You will find a detailed description on → Page 44.
*F-CHIP → Page 115
1
45
6
2
3
+24.502
+1863.97
x
x
y
y
–50
+50
%
v
v
3
S