Proline Promass 83 PROFIBUS DP/PA Commissioning
Endress+Hauser 61
6.3.2 Quick Setup “Batching”
!
Note!
This function is only available when the additional “batching” software is installed in the measuring
device (order option). You can order this software from Endress+Hauser as an accessory at a later
date. → Page 117
This Quick Setup menu guides you systematically through the setup procedure for all the device
functions that have to be parameterised and configured for batching operation. These basic settings
allow simple (one step) batching processes.
Additional settings, e.g. for the calculation of after runs or for multi-stage batching procedures, must
be made via the function matrix itself (see the “Description of Device Functions” manual).
"
Caution!
The “Batching” Quick Setup sets certain device parameters for discontinuous measurement
operation.
If the measuring instrument is used for continuous flow measurement at a later time, we
recommend that you rerun the “Commissioning” and/or “Pulsating Flow” Quick Setup.
!
Note!
• Before carrying out the Quick Setup “Batching” the Quick Setup “Commissioning” has to be
executed. → Page 59
• You can find detailed information on the batching functions in the separate “Description of Device
Functions” manual”.
• You can also directly control filling process using the local display. During Quick Setup, an
appropriate dialogue appears concerning the automatic display configuration. Acknowledge this
by clicking “YES”.
This assigns special batching functions (START, PRESET, MATRIX) to the bottom line of the
display. These can be directly executed on-site using the three operating keys ( O / S / F ).
• You can also directly control the filling process using the fieldbus.
To Next Page
Loading...
