Endress+Hauser Proline Promass 83 - Group CONTROL

Proline Promass 83 PROFIBUS DP/PA Installation
Endress+Hauser 23
3.3.2 Installing the wall-mount transmitter housing
There are various ways of installing the wall-mount transmitter housing:
• Mounted directly on the wall
• Installation in control panel (separate mounting set, accessories) → Page 24
• Pipe mounting (separate mounting set, accessories) → Page 24
"
Caution!
• Make sure that ambient temperature does not go beyond the permissible range (– 20...+60 °C,
optional – 40...+60 °C). Install the device in a shady location. Avoid direct sunlight.
• Always install the wall-mount housing in such a way that the cable entries are pointing down.
Mounted directly on the wall
1. Drill the holes as illustrated in the diagram.
2. Remove the cover of the connection compartment (a).
3. Push the two securing screws (b) through the appropriate bores (c) in the housing.
– Securing screws (M6): max. Ø 6.5 mm
– Screw head: max. Ø 10.5 mm
4. Secure the transmitter housing to the wall as indicated.
5. Screw the cover of the connection compartment (a) firmly onto the housing.
a0001130
Fig. 13: Mounted directly on the wall
90
35
a
b
192
81.5
c
c