Identification Proline Promass 83 PROFIBUS DP/PA
14 Endress+Hauser
2.2 Certificates and approvals
The devices are designed in accordance with good engineering practice to meet state-of-the-art
safety requirements, have been tested, and left the factory in a condition in which they are safe to
operate. The devices comply with the applicable standards and regulations in accordance with
EN 61010 “Protection Measures for Electrical Equipment for Measurement, Control, Regulation
and Laboratory Procedures” and with the EMC requirements of EN 61326/A1.
The measuring system described in these Operating Instructions thus complies with the statutory
requirements of the EC Directives. Endress+Hauser confirms successful testing of the device by
affixing to it the CE mark.
The Promass 83 flowmeter has successfully passed all the test procedures carried out and is certified
and registered by the PNO (PROFIBUS User Organisation).
The device thus meets all the requirements of the following specifications:
• Certified to PROFIBUS Specification Profile 3.0 version
Device certification number: on request
• The measuring device can also be operated with certified devices of other manufacturers
(interoperability).
2.3 Registered trademarks
KALREZ
®
and VITON
®
Registered trademarks of E.I. Du Pont de Nemours & Co., Wilmington, USA
TRI-CLAMP
®
Registered trademark of Ladish & Co., Inc., Kenosha, USA
SWAGELOK
®
Registered trademark of Swagelok & Co., Solon, USA
PROFIBUS®
Registered trademark of the PROFIBUS User Organisation, Karlsruhe, D
HistoROM™, S-DAT
®
, T-DAT™, F-CHIP
®
, ToF Tool - Fieldtool
®
Package, Fieldcheck
®
,
Applicator
®
Registered or registration-pending trademarks of Endress+Hauser Flowtec AG, Reinach, CH
To Next Page
Loading...
