Endress+Hauser Proline Promass F 300 - Page 117

Proline Promass F 300 EtherNet/IP Commissioning
117
Measuring value at maximum
frequency
→  120
Failure mode
→  121
Failure frequency
→  121
Invert output signal
→  121
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
• Frequency
• Switch
Pulse
Terminal number – Shows the terminal numbers
used by the PFS output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–
Signal mode – Select the signal mode for the
PFS output.
• Passive
• Active
Passive