Endress+Hauser Proline Promass F 300 - Page 122

Commissioning Proline Promass F 300 EtherNet/IP
122
Configuring the switch output
Navigation
"Setup" menu → Pulse/frequency/switch output
‣
Pulse/frequency/switch output
1 to n
Operating mode
→  122
Terminal number
→  122
Signal mode
→  123
Switch output function
→  123
Assign diagnostic behavior
→  123
Assign limit
→  124
Assign flow direction check
→  124
Assign status
→  124
Switch-on value
→  125
Switch-off value
→  125
Switch-on delay
→  125
Switch-off delay
→  125
Failure mode
→  125
Invert output signal
→  125
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
• Frequency
• Switch
Pulse
Terminal number – Shows the terminal numbers
used by the PFS output
module.
• Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
–