EnGenius EOC2611P - Understanding the Hardware; 2.1 Hardware Installation

2 UnderstandingtheHardware

2.1 HardwareInstallation
1. Placetheunitinanappropriatelocationafterconductingasitesurvey.
2. Plug one end of the Ethernet cableinto the Network port of the PoE injector and anotherend
intoyourPC/Notebook.
3. PlugoneendofanotherEthernetcabletoAP/BridgeportofthePoEinjectorand
theotherend
intoyoucable/DSLmodem(Internet)
4. InserttheDC‐inletofthepoweradapterintothe24VportofthePoEinjectorandtheotherend
intothepowersocketonthewall.

Thisdiagramdepictsthehardwareconfiguration










2.2 HardwareDescription
Theimagesbelowdepictthefrontandrearpaneloftheunit.






















Front Panel Rear Panel