Enterasys SSA-G1018-0652 User Manual

Mounting the SSA
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-9
4. Attachtherailstotherackposts.SeeFigure 2‐5.
a. Securethefrontoftherailtothefrontoftherackpostwithcustomer‐suppliedscrewsin
thetopandbottomscrewholes.
b. Securethemountingbrackettothebackoftherackpostwithcustomer‐suppliedscrews
inthe
topandbottomscrewholes.
TheSSArailkitdoesnotincludescrewsforattachingtherailsandmountingbracketstothe
rackposts.
5. Tightenthe6‐32screwsthatsecurethemountingbracketstotherails.
6. SlidetheSSAontotherailsuntilthefrontoftheSSAisagainst
thefrontoftherackposts.
7. SecurethefrontoftheSSAtotherackbyscrewingthecustomer‐suppliedrackscrewsinthe
mountingearsontherightandleftfrontoftheSSA.
8. (Optional)SecuretherearoftheSSAtotherails.See“SecuringtheSSAto
theRearofthe
Rails”onpage 2‐11.
YoucannowunpackandinstalltheSSApowersupplies.See“UnpackingthePowerSupplies”on
page 2‐12and“InstallingthePowerSupplies”onpage 2‐13.

Enterasys SSA-G1018-0652 Specifications

General

Brand	Enterasys
Model	SSA-G1018-0652
Category	Switch
Language	English