iPAK2 User Guide
77
13.6. Setting the IP address
13.6.1. iPAK2v2
This model has an integrated Ethernet sub-system for Ethernet and EtherNet/IP
communications on COM4, COM5 and COM6. The IP address may be set in the
configuration with NetFlash or WSP3.
13.6.2. iPAK2
If an EtherNet/IP adapter board has been fitted, then this has its own IP address (for COM4,
COM5 and COM6) which can be set as shown above for the iPAK2v2.
The port on the main board uses a device server for Ethernet communications on COM0
and COM1. The device server is an xPort AR device, manufactured by Lantronix. To set the
IP address of the main board port on iPAK2, use Lantronix DeviceInstaller software
www.lantronix.com/products/deviceinstaller/
Note: This method also works for the EtherNet/IP adapter board (if fitted) and iPAK2v2.
Download the documentation and Device Installer software. Install the software.
Follow the instructions in the documentation to search for all Lantronix devices on
your network. Device Installer will show the iPAK2 device server in the device list.
The example shows an iPAK2/xPort AR with a hardware address of 00-20-4A-D5-FB-
7B:
To Next Page
Loading...
