Section 14: In Case of Difficulty
172
11. Set it to Send Bands to Driver
12. Then find the option Text Output Method
13. Set it to All Text as Graphics
14. Verify that Corel 6.0 is version .176; follow the instructions above for
verification and updates.
Problem: Inadequate Exhaust.
Solution:
1. The closer the blower is to the machine the better exhaust you will receive.
2. If you are using flex hose, do not bundle up the excess. Stretch out the flex
hose, cut it to desired length and use only what you need.
3. Clean your exhaust system on a regular basis including engraver and blower.
Use a bottlebrush and a vacuum on the areas where the exhaust buildup
accumulates.
Problem: Engraver will not power up. Nothing transpires when engraver is
turned on.
Solution:
1. Verify there is power being supplied to the engraver, that your outlet is in good
working condition and that the engraver is actually plugged in.
2. Check to make sure the carriage can be moved freely with the power off. If the
engraver can’t find the home position, it will not power up properly.
Problem: Poor engraving quality.
Solution:
1. If you feel you are not getting the depth that you once were, this is probably a
maintenance issue. See the maintenance section of the manual (Section 12) for
instructions on cleaning the optics. If you are not sure of the location of all of
your mirrors, contact Epilog technical support at Technical Support at (303)
215-9171.
2. If you are experiencing a blurry or erratic image, check to make sure you are in
focus and all optics are clean.
To Next Page
Loading...
Need help?
General
