Epson AcuLaser C2800 - Page 296

AcuLaser C2800/C2800D/C3800/C3800D Revision C
DISASSEMBLY/REASSEMBLY Disassembly/Reassembly 296
Confidential
HOUSING ASSY B
C H E C K
P O I N T
The mid-connector should remain connected to the main unit.
1. Release the connectors and the harnesses of the four MOTOR ASSY DISPs from the DUCT
HARNESS MOT, and disconnect the connectors of the MOTOR ASSY DISPs.
2. Release the two tabs that secure the DUCT HARNESS MOT to the main unit.
3. Slightly slide the DUCT HARNESS MOT upward, release the protrusion of the DUCT HARNESS
MOT from the main unit, pull out the four connectors of the MOTOR ASSY DISP through the holes
in the DUCT HARNESS MOT, and remove the DUCT HARNESS MOT.
NEXT>>
C
1)
1)
1)
2)
2)
3)
1)
Kmy03081E
A
4. Remove the screw (silver, self-tapping, 10 mm) that secures the SPRING ESA ROLL to the
HOUSING ASSY B.
5. Remove the SPRING ESA ROLL from both the HOUSING ASSY B and the main unit.
6. Remove the three screws (silver, self-tapping, 10 mm) that secure the HOUSING ASSY B.
7. Remove the HOUSING ASSY B from the main unit.
Kmy03040EA
4)
6)
7)
6)
6)
5)
HOUSING ASSY B